Stickist.com
https://stickist.com/

Buffer/Splitter project
https://stickist.com/viewtopic.php?f=4&t=12418		 Page 1 of 1
Author:  pcgonzales [ Mon Aug 07, 2017 3:54 pm ]
Post subject:  Buffer/Splitter project
Just completed a pretty cool project multi output splitter with independent buffers for each output. The Author of the project specs, claims there should be no crosstalk between each outputs. I've only had a chance to play thru it for a few hours yesterday but I do have to say it does separate channels really well! I setup my pedals with a really heavy distortion from one output into my "board" (its not mounted yet) and ran 2 additional outs from the unit to my mixer where I had panned hard left and hard right with differing amounts of reverb. It worked beautifully, the dirty channel combined with the other 2 clean channels sounded so thick. I played with differing levels to see that there was no distortion bleeding in. Much fun.
Got the plan from AMZFX here: http://www.muzique.com/lab/splitter.htm
Author:  Jayesskerr [ Mon Aug 07, 2017 6:35 pm ]
Post subject:  Re: Buffer/Splitter project
Really cool, man!
Author:  earthgene [ Mon Aug 07, 2017 8:16 pm ]
Post subject:  Re: Buffer/Splitter project
Nicely done PCg.
Author:  pcgonzales [ Mon Aug 07, 2017 8:36 pm ]
Post subject:  Re: Buffer/Splitter project
Thanks Gents!

I wish I could do a comparison video but I'd have to have a passive splitter, instead I'll do a demo of the new board when I'm done collecting all the pedals I want. Then I can show the multi channel separation etc..
Author:  earthgene [ Tue Aug 08, 2017 8:43 am ]
Post subject:  Re: Buffer/Splitter project
I have enjoyed running multiple signal paths for my melody side utilizing the m400se volume / expression pedal. I am downsizing my board by about 40%, so I'll be looking to replace it with an Xotic Blender. I still have to sell off some other gear first, but that is the plan.

Looking forward to updates.
Author:  pcgonzales [ Wed Aug 09, 2017 3:35 pm ]
Post subject:  Re: Buffer/Splitter project
earthgene wrote:
I have enjoyed running multiple signal paths for my melody side utilizing the m400se volume / expression pedal. I am downsizing my board by about 40%, so I'll be looking to replace it with an Xotic Blender. I still have to sell off some other gear first, but that is the plan.

Looking forward to updates.

What is a "m400se"?
Author:  earthgene [ Wed Aug 09, 2017 5:00 pm ]
Post subject:  Re: Buffer/Splitter project


One of my faves!
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/